FU-BLE-B20P1 Bluetooth AOA positioning starts from the base station

Overview

Interface Description

1) RJ45 Interface: Features PoE IN function, serving as both a power supply and data transmission interface. It can be connected to a standard PoE switch via a network cable.

2) Reset Hole: Button to restore default settings. Press and hold for 3s. If the base station's green light flashes quickly for 3 seconds, it indicates that the base station has successfully restored to its initial settings and restarted.

3) DC Power Interface: Connect to a DC power supply to power the base station.

 

Installation Instructions

* Before installation, please confirm that the mounting location can bear a weight of 2kg or more.

1) As shown in the figure on the right, use KA3.5 screws to firmly install the mounting bracket on the flat ceiling (in the direction indicated by the arrow).

2) Align with the mounting bracket's buckle, and push the base station into the bracket's slot. The network port direction indicated on the bracket's buckle surface should match the network port direction indicated on the back of the base station.

3) Connect the base station's RJ45 interface (PoE IN) to the PoE switch using a PoE network cable.

 

Indicator Light Signal Rules

1) After the base station is correctly installed and cascaded with the PoE switch, it will start automatically. After startup, the operating status of the base station can be determined by the indicator lights.

2) The signal rules for the LED indicator lights are shown in the table below.

Light Status	Base Station Status
Green light flashes rapidly for 5s	Base station starting / Restarting via long press of reset button
Red light flashes rapidly	Acquiring IP address
Green light flashes slowly	Successfully acquired IP address
Green light stays on	Successfully connected to positioning engine
Red light stays on. After 30s, the base station automatically resets	Local base station fault / not connected
Red and green lights flash slowly alternately	Cascaded lower-level base station fault
Light off	No power connection

 

Precautions

1) When choosing PoE power supply for the positioning base station, you must use the designated standard PoE power supply equipment (PSE equipment compliant with the IEEE 802.3af / 802.3at protocols).

2) The operating environment temperature range for the base station is -20℃ ~ 60℃, humidity 0-95%. Keep it away from fire sources and electromagnetic interference sources.

3) Supports upper-layer application development on Web and Android platforms.

 

Installation Checklist

Item	Quantity
FU-BLE-B20P1	1
Mounting bracket	1
Certificate of Conformity	1
Installation screws KA3.5*30 and plastic anchors	(1 screw + 1 anchor) × 3

Specifications