FU-OD-04 UWB Proximity Warning Base Station - Specification Sheet

Overview

Proximity warning instructions

Function	Explanation
Real-time precise ranging	High-precision real-time distance measurement both indoors and outdoors to achieve proximity alarm
One-click alarm	The label has a one-button alarm function (long press to alarm)
Electronic Fence management	Multiple types of area regulations (safety, warning, danger), various trigger methods (entry, exit, entry and exit), and multiple alarm methods (background push, sound prompt)
Location Service API	Personnel location coordinates, sensor information (battery level, etc.), personnel information, etc

After the proximity warning base station is connected to the power supply, the base station needs to self-check for 30 seconds to 1 minute when it starts up. After the device starts up normally, when the positioning tag enters the alarm area set by the base station (the default alarm distance is 10 meters, which can be changed according to on-site needs), the positioning tag end will emit an alarm sound of "beep beep beep" (it can be set to alarm continuously or only three times). If an alarm is also required at the base station end, a voice alarm can be connected externally at the base station end (it needs to be customized in advance, and the type picture is as follows). The content of the voice alarm can be changed according to the customer's requirements.

If the tag does not go into sleep mode and remains within the alarm area set by the base station, the voice alarm device and the positioning tag will continuously sound the alarm. If the tag goes into sleep mode or leaves the alarm area range set by the base station, the voice alarm will stop sounding.

• 
• 

Specifications

Installation Instructions

Base station assembly: Select one of Ethernet, WIFI, or 4G based on the network.

A. Use A 4G card

A. Unscrew the four hexagonal screws on the front of the base station

B. Open the cover and install the 4G card into the card slot Shenzhen Fuwit Technology Co.,Ltd https://www.fuwit.com.cn

C. Correct the cover and use an Allen wrench to tighten the screws diagonally

D. Connect the UWB and 4G antennas.

E. Connect the power supply and the base station will operate normally online

B. Use Ethernet

When the power is connected, the base station operates normally.

C. Use Wifi

A. Change the WIFI account and password to the base station setting wifi account and password, and connect to wifi within the wifi signal coverage area. Connect

The base station works normally after the power is supplied

B. Change the wifi account and password of the base station to the account and password specified by the customer. Connect to wifi and power on within the wifi signal coverage area

The base station behind the source is functioning normally.

Base station installation

1. Use screws to fix and install the L-shaped bracket to the side snap of the base station.

2. Fix the base station to the installation pole with U-shaped clamps and L-frames.

3. Install the UWB antenna, 4G antenna and 2.4G antenna of the base station accordingly.

4. Fix the base station to the installation point;

5. Connect the power supply and approach the UWB antenna and positioning tag of the early warning base station in an unobstructed state.

Notes & Packaging

Stay away from fire sources and strong electromagnetic interference sources